28
12. Press the “UP” side of PTT switch three
times within three seconds. The buzzer will
sound one time briefly indicating the setting
has been accepted.
13. Return the throttle to the fully closed posi-
tion and install the lock plate on the emer-
gency switch. Operate the full tilt up and full
down operations several times by pressing
the PTT switch and check that the setting of
both the trim lower limit and tilt upper limit
are properly set.
WARNING
Setting of the tilt upper limit position will
not prevent the outboard motor from tilt-
ing fully up and contacting the motor well
if the motor’s lower unit hits an object at
high speed. Such tilting could damage
your motor and boat and injure the boat
occupants.
Keep all occupants away from the motor
when operating at high speed.
MOTOR COVER FASTENING
ADJUSTMENT
If you feel motor cover fastening is loose or too
tight when locking the levers, adjust as follows:
1. Loosen the bolts
1
,
2
and
3
.
2. Adjust the position of brackets
4
,
5
and
6
.
To increase the fastening, move the brackets
to the direction
A
. To decrease the fasten-
ing, move the brackets to the direction
B
.
3. Tighten the bolts.
Motor cover