ENGINE 3-17
• Hold the clutch housing with the special tool.
09920-53740: Clutch sleeve hub holder
• Remove the clutch springs.
NOTE:
Loosen the clutch spring set bolts little by little and diagonally.
• Remove the pressure plate
3
.
• Remove the clutch drive plates
4
and driven plates
5
.
• Remove the clutch push piece
6
, thrust washer
7
and bear-
ing
8
.
• Remove the spring washer
9
and its seat
0
.
• Remove the clutch push rod
A
.
NOTE:
If it is difficult to pull out the push rod
A
, use a magnetic hand or
a wire.
• Unlock the clutch sleeve hub nut.
Do not damage the clutch plates by the special tool.
Summary of Contents for 2006 gsxr 600
