3-74 ENGINE
ENGINE REASSEMBLY
• Reassemble the engine in the reverse order of disassembly.
• The following steps require special attention or precautionary
measures should be taken.
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
• Be sure to install the following items to the crankcase.
* Crankshaft journal bearings (
3-71)
* Driveshaft (
3-57)
* Gearshift fork shafts (
3-44)
* Gearshift shaft bearings (
3-56)
* Gearshift cam bearings (
3-56)
* Gearshift cam (
3-57)
* Driveshaft bearings (
3-57)
* Oil jets (
3-59)
PISTON RING
• Install the piston rings in the order of oil ring, 2nd ring and 1st
ring.
• The first member to go into the oil ring groove is a spacer
1
.
After placing the spacer, fit the two side rails
2
.
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: you can position each either way.
A
INCORRECT
B
CORRECT
• Install the 2nd ring
3
and the 1st ring
4
to the piston.
NOTE:
1st ring and 2nd ring differ in shape.
When installing the spacer, be careful not to allow its
two ends to overlap in the groove.
Summary of Contents for 2006 gsxr 600
