d) Using a wedging tool or flat head screwdriver, gently remove the
¾” gasket (along with the
silicone) from the door framing.
e) Using a wrench, remove the 8 nuts fastened around the door framing.
f) Remove the first row of metal brackets (2 small and 2 big) and thin gasket.
g) Remove the damage glass and clean thoroughly the door framing from loose glass fragments.
h) Place the new glass onto the second row of thin gasket, centered with the door framing.
i) Place back the first row of metal brackets (2 small and 2 big) and thin gasket.
j) Using a wrench, fasten the 8 nuts around the door framing (do not over-tighten).
k) Apply a bead of high temperature silicone along the groove of the metal brackets.
l) Place t
he ¾” gasket back into position.
Give significant amount of time to allow the silicone to cure before reinstalling the door onto the
firebox.
Table 4: Assembly List for Door
6.6 Door Latch Lubrication
Lightly lubricate the hook of door latch (CM0031) on a yearly basis to prevent abrasive wear.
6.7 Paint
Paint touch-ups can be performed on the unit using a high temperature paint (in aerosol spray can
format) by Stove Bright®. Refer to your invoice to determine the precise color of your unit. Contact
your local hearth shop for further information on purchasing this paint.
NOTE: Apply the paint in a well ventilated area. If applying paint to the door, properly cover/mask the
glass of the door using painters tape and cardboard. Wait for paint to dry before operating the unit.
Refer to the instructions on the label of the aerosol spray can for proper paint application.
WARNING:
Never apply paint to the unit during operation or when it is hot.
6.8 Removal of Firebox
Occasionally, a technician or an inspector may require the firebox to be temporarily removed from the
masonry fireplace; therefore, refer to the following instructions for proper removal of the firebox:
a) Remove and dispose any ashes from within the firebox (see Section 5.1)
b) Remove the door of the firebox and place it at a safe location to avoid any damage.
c) Remove the surround of the unit by unscrewing the 4 screws at each corner of the door holder.
d) From within the firebox, displace the chimney sweeping cap located in the baffle by lifting and
moving it to the side (see Figure 7).
e) Straighten the clips of the adaptor.
f) Use the handle to push the adaptor upwards and disconnect it from the firebox.
g) Safely remove the firebox.
Refer to Section 2.3 for reinstalling the firebox.
CAUTION: Never remove the firebox while still in operation (hot).
Item
Code
Description
Qty
1
DR2110
Door frame assembly
1
2
DR_25375
Horizontal metallic bracket
4
2
DR_14875
Vertical metallic bracket
4
3
PYRO_24.25X13.625
Pyroceram glass
1
4
GSK_19_7
Thin gasket
2
5
GSK_25_7
Thick gasket
1
6
CM0031
Door latch
1
7
POI
Wood pull handle
1
Figure 26: Exploded View of Door Assembly
18
