Supero SuperWorkstation 7045A-3, User Manual

Page: 63 / 120

Chapter 6: Advanced Chassis Setup
6-3
6-2 Front Control Panel
The front control panel must be connected to the JF1 connector on the serverboard
to provide you with system status and alarm indications. A ribbon cable has bundled
these wires together to simplify this connection. Connect the cable from JF1 on the
serverboard (making sure the red wire plugs into pin 1) to the appropriate comnnec-
tor on the front control panel PCB (printed circuit board). Pull all excess cabling over
to the control panel side of the chassis. The LEDs on the control panel inform you
of system status - see Figure 6-2 for details. See Chapter 5 for details on JF1.
Figure 6-2. Front Control Panel LEDs
Power
NIC
HDD
Power Fail
Overheat
Indicates power is being supplied to the system.
Indicates network activity on GLAN port 1.
Indicates IDE device and hard drive activity. On the
7045A-3, this LED indicates SAS/SATA hard drive activity
when fl ashing.
Non-applicable (for redundant power supply systems
only).
When this LED fl ashes, it indicates a fan failure. When
on continuously it indicates an overheat condition (see
Chapter 3 for details).
NIC
Indicates network activity on GLAN port 2.