Supero SuperWorkstation 7045A-3, User Manual

Page: 55 / 120

Chapter 5: Advanced Serverboard Setup
5-21
Compact Flash Master/Slave
Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select jumper is located at
JCF1. Close this jumper to enable the
use of a compact fl ash card. For the
compact fl ash card and JCF1 to work
properly, you will fi rst need to connect
the compact fl ash card's power cable to
JWF1. See the table on the right for
jumper settings.
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Defi nition
Open Slave (Secondary)
Closed Master (Primary)
I
2
C Bus to PCI
Jumpers JI
2
C1, JI
2
C2, JI
2
C3 and JI
2
C4
allow you to connect specifi c PCI-
X/PCI-Express slots to the System
Management (I
2
C) Bus. The default
setting for all jumpers is pins 2-3 to
disable the connection.
These jumpers must be set in pairs.
JI
2
C1 and JI
2
C2 are for PCI-X slot
#1 and JI
2
C3 and JI
2
C4 are for PCI-
Express slot #6. Each pair of jump-
ers must be set to the same setting.
See the table on the right for jumper
settings.
I 2 C Bus to PCI
Jumper Settings
(JI
2
C1/JI
2
C2/JI
2
C3/JI
2
C4)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SAS Controller Enable/
Disable
JPS1 enables or disables the AIC
9140W Adaptec SAS controller on the
serverboard. See the table on the right
for jumper settings. The default setting
is enabled.
SAS Controller Enable
Jumper Settings (JPS1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled