Supero SuperWorkstation 7045A-3, User Manual

Page: 50 / 120

5-16
S
UPER
W
ORKSTATION 7045A-3 User's Manual
ATX PS/2 Keyboard and
PS/2 Mouse Ports
The ATX PS/2 keyboard and the PS/2
mouse ports are located on the I/O
back plane. See the table on the right
for pin defi nitions.
Power LED/Speaker
On the JDI header, pins 1-3 are for
a power LED, pins 4-7 are for the
speaker. See the table on the right
for speaker pin definitions. Note:
The speaker connector pins are for
use with an external speaker. If you
wish to use the onboard speaker, you
should close pins 6-7 with a jumper.
PS/2 Keyboard and
Mouse Port Pin
Defi nitions (Kb, Mouse)
Pin# Defi nition
1 Data
2 NC
3 Ground
4 VCC
5 Clock
6 NC
Speaker Connector
Pin Defi nitions (JD1)
Pin # Function Defi nition
4 + Speaker data (red wire)
5 Key No connection
6 Key
7 Speaker data
Universal Serial Bus
Headers
Two additional USB headers are
located near the SATA5 header on
the serverboard. This header is
designated USB4/5 and is included
for connection to the USB ports on
the front of the chassis. A USB cable
(not included) is needed for the con-
nection. See the table on the right for
pin defi nitions.
Universal Serial Bus Headers
Pin Defi nitions (USB4/5)
USB2
Pin # Defi nition USB3
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 N/A 5 N/A
SGPIO Headers
Two SGPIO (Serial General Purpose
Input/Output) headers have been
included on the X7DA3. These headers
support serial link interfaces for the
onboard SATA connectors. See the
table on the right for pin defi nitions.
SGPIO Headers
Pin Defi nitions (SGPIO1/SGPIO2)
Pin# Defi nition Pin Defi nition
1 *NC 2 *NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 *NC