Supero SuperWorkstation 5033C-T, User Manual

Page: 72 / 96

7-8
S
UPER
W
ORKSTATION 5033C-T User's Manual
UART Mode Select
This setting allows the user to select the UART mode for the BIOS. The
options are "IrDA", "ASKIR" and " Normal ".
RxD, TxD Active
This allows the user to change the settings for the "RxD, TxD Active"
function. The options are "Hi, Hi", " Hi, Lo ", "Lo, Hi", and "Lo, Lo".
IR Transmission Delay
If "Enabled", the transmission of IR (infrared) signals will be delayed. The
options are " Enabled " and "Disabled".
UR2 Duplex Mode
This setting set the mode for the UR2 Duplex Mode. The options are "Full"
and " Half ".
Use IR Pins
This item sets the usage of the IR pins. The options are "RxD2, TxD2" and
" IR-Rx2Tx2 ".
Onboard Parallel Port
This setting allows the user to set the address and the corresponding IRQ
for the onboard parallel port. The options are "Disabled", " 378/IRQ7 ", "278/
IRQ5" and "3BC/IRQ7".
Parallel Port Mode
This setting sets the mode for the onboard Parallel port. The options are
" SPP ," "EPP", "ECP" "ECP+EPP" and "Normal".
EPP Mode Select
This setting allows the user to select the EPP port type. The options are
"EPP 1.9" and " EPP 1.7 ".
ECP Mode Use DMA
This setting allows the user to select the DMA channel for the ECP mode
(port) to use. The options are "1" and " 3 ".
Watch Dog Timer Select
This setting allows you to select the setting for the Watch Dog Timer. The
Options are " Disabled ", "10 Sec", "20 Sec", "30 Sec", "40 Sec", "I min", "2
min",and "4 min".