Supero SuperWorkstation 5033C-T, User Manual

Page: 13 / 96

Chapter 1: Introduction
1-3
Processors
The P4SCT+II supports a single Intel
®
Pentium
®
4 HT (hyper-threading) proces-
sor of up to 3.40 GHz with an integrated 512KB advanced transfer cache or Intel
®
Celeron
®
processors of up to 2.80 GHz with an integrated 128KB advanced
transfer cache. Please refer to the support section of our web site for a complete
listing of supported processors (http://www.supermicro.com/support/).
Memory
The P4SCT+II has four (4) 184-pin DIMM sockets that can support up to 4 GB
of ECC or non-ECC unbuffered DDR400/333/266 SDRAM modules. (Memory
operates in a dual-channel, or interleaved configuration for increased perfor-
mance.) Module sizes of 128 MB, 256 MB, 512 MB and 1 GB may be used to
populate the DIMM slots.
Serial ATA
A Serial ATA controller is incorporated into the 875P chipset to provide a two-
port Serial ATA subsystem. A Marvell 88SX5080 controller is also included
onboard the P4SCT+II, which provides support for four additional SATA ports.
The SATA drives are hot-swappable units and RAID 0 and RAID 1 supported.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
PCI Expansion Slots
The P4SCT+II has two 32-bit, 33 MHz (5V) PCI slots and three 64-bit, 66 MHz
(3.3V) PCI-X slots. The SC733T-350 chassis can accommodate cards being
installed in all five slots.
Ethernet Ports
The P4SCT+II has an Intel
®
82547GI CSA Gigabit Ethernet controller and an
Intel
®
82541 Gigabit Ethernet controller onboard. Together these controllers can
support a total of two Gigabit LAN ports.
AGP Slot
A 15.V 8xAGP slot for use with high-performance video cards is included on the
motherboard. The AGP slot is backward compatible with 4xAGP and 2xAGP.