Supero SuperWorkstation 5033C-T, User Manual

Page: 35 / 96

Chapter 5: Advanced Motherboard Setup
5-5
5-5 Installing Processors
Avoid placing direct pressure to the top of the processor
package. Always remove the power cord first before adding,
removing or changing any hardware components.
Processor Support
The P4SCT+II has a single 478-pin microPGA socket, which supports Intel
Pentium 4 processors on .013 micron process.
!
2. Lift the lever on the CPU socket.
3. Install the CPU in the socket by aligning the pins to the holes in the socket.
Make sure that Pin 1 of the CPU is seated on Pin 1 of the socket (both corners
are marked with a triangle).
4. Press the lever down until you hear it *click* into the locked position.
5. To install the heatsink, please refer to the instructions that came with the Intel
heatsink, which you should have received in the same package as the Pentium
4 processor. (You may also refer to http://www.intel.com/support/processors/
manuals/p4pman2.htm).
1. Begin by installing the CPU heatsink mechanism by screwing it into the holes
on either side of the CPU socket.
Figure 5-3. 478-pin Socket: Empty and with Processor Installed