Supero SuperWorkstation 5033C-T, User Manual

Page: 62 / 96

6-10
S
UPER
W
ORKSTATION 5033C-T Manual
Installing Components in the 5.25" Drive Bays
1. Drive bay configuration
The 5033C-T has two 5.25" drive bays above the SATA drive bays. Compo-
nents such as a floppy drive, IDE hard drives or CD-ROM drives can be
installed in these 5.25" drive bays.
2. Mounting components in the drive bays
First power down the system and then remove the top/left chassis cover
to access the drive components. With the cover off, remove the two or
four screws that secure the drive carrier to the chassis (one side only)
then push the entire empty drive carrier out from the back.
Adding a CD-ROM drive: remove the guide plate from right side of the
empty drive carrier and screw it into the right side of the CD-ROM drive
using the holes provided (see Figure 6-8). Then slide the CD-ROM into the
bay and secure it to the chassis with the drive carrier screws you first
removed. Attach the power and data cables to the drive. Replace the top/left
chassis cover before restoring power to the system.
Adding an IDE or floppy drive: to add one of these drives, install it into one of
the removed empty drive carriers with the printed circuit board side toward the
carrier so that the drive's mounting holes align with those in the carrier.
Secure the drive to the carrier with four screws then slide the assembly into
the bay and secure it to the chassis with the drive carrier screws you first
removed. Attach the power and data cables to the drive. Replace the top/left
chassis cover before restoring power to the system.
Note: A red wire typically designates the location of pin 1. You should keep
the drive carriers inserted in any unused drive bays to reduce EMI and noise
and to facilitate the airflow inside the chassis.
Figure 6-8. Adding a Component Without a Drive Carrier