Supero SuperWorkstation 5033C-T, User Manual

Page: 20 / 96

2-2
S
UPER
W
ORKSTATION 5033C-T User's Manual
2-3 Setting Up the System
You should first open the left side panel (when facing the front of the chassis) to
make sure the motherboard is properly installed and all connections have been
made.
Checking the Motherboard Setup
1. Accessing the inside of the 5033C-T (Figure 2-1)
Begin by removing the two screws from the back lip of the side cover (this
is the left cover when looking at the chassis from the front.) Grab the handle
and gently pull the side cover out to release it from its position. Once the side
cover is out of its position, slide the cover out of the chassis.
2. Check the CPU (processor)
You may have one processor already installed into the system board. The
processor should have its own heatsink attached. See Chapter 5 for instruc-
tions on processor installation.
3. Check the system memory
Your 5033C-T system may have come with system memory already installed.
Make sure all DIMMs are fully seated in their slots. For details on adding
system memory, refer to Chapter 5.
4. Installing add-on cards
If desired, you can install up to five add-on cards to the system. See Chapter
5 for details on installing PCI-X/PCI add-on cards.
5. Check all cable connections and airflow
Make sure all power and data cables are properly connected and not
blocking the airflow. See Chapter 5 for details on cable connections.