Supero SUPERSERVER 6026T-TF, User Manual

Page: 27 / 106

Chapter 3: System Interface
3-3
Overheat/Fan Fail:
•
When this LED fl ashes it indicates a fan failure. When
continuously on (not fl ashing) it indicates an overheat condition, which may be
caused by cables obstructing the airfl ow in the system or the ambient room
temperature being too warm. Check the routing of the cables and make sure
all fans are present and operating normally. You should also check to make
sure that the chassis covers are installed. Finally, verify that the heatsinks are
installed properly. This LED will remain fl ashing or on as long as the overheat
condition exists.
3-4 Drive Carrier LEDs
Each drive carrier has two LEDs:
SATA Drives
Green:
•
When illuminated, the green LED on the SATA drive carrier indicates
drive activity. A connection to the SATA backplane enables this LED to blink
on and off when that particular drive is being accessed. Please refer to Chapter
6 for instructions on replacing failed SATA drives.
Red:
•
When this LED fl ashes it indicates the drive is rebuilding. When solid on
it indicates a SATA drive failure. If a drive fails, you should be notifi ed by your
system management software. Please refer to Chapter 6 for instructions on
replacing failed drives.