A-4
S
UPER
S
ERVER 5015B-T User's Manual
Fixed Disk n
Fixed disk
n
(0-3) identifi ed.
Invalid System Confi guration Data
Problem with NVRAM (CMOS) data.
I/O device IRQ confl ict
I/O device IRQ confl ict error.
PS/2 Mouse Boot Summary Screen:
PS/2 Mouse installed.
nnnn kB Extended RAM Passed
Where
nnnn
is the amount of RAM in kilobytes successfully tested.
nnnn Cache SRAM Passed
Where
nnnn
is the amount of system cache in kilobytes successfully tested.
nnnn kB Shadow RAM Passed
Where
nnnn
is the amount of shadow RAM in kilobytes successfully tested.
nnnn kB System RAM Passed
Where
nnnn
is the amount of system RAM in kilobytes successfully tested.
One or more I2O Block Storage Devices were excluded from the Setup Boot
Menu
There was not enough room in the IPL table to display all installed I2O block-stor-
age devices.
Operating system not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and
see if fi xed disk and drive A: are properly identifi ed.
Parity Check 1 nnnn
Parity error found in the system bus. BIOS attempts to locate the address and
display it on the screen. If it cannot locate the address, it displays
????.
Parity is a
method for checking errors in binary data. A parity error indicates that some data
has been corrupted.
Summary of Contents for SUPERSERVER 5015B-T
