Supero SuperServer 5012B-6, User Manual

Page: 59 / 112

Chapter 5: Advanced Motherboard Setup
5-21
USB Wake-Up
Jumper JP37 is used in conjunc-
tion with the Keyboard Wake-Up
function in BIOS to wake the sys-
tem up with a USB keyboard that
has been connected to a USB port
(not header). Set JP37 to pins 1-2
to support USB keyboard wake-up
and resume from ACPI S1 mode
and pins 2-3 pins to support USB
k e y b o a r d w a k e - u p a n d r e s u m e
from ACPI S3 mode. See the table
on the right for jumper settings.
Note: Your power supply must
provide 5v of standby voltage with
at least 1A to use this feature.
Jumper
Position
1-2
2-3
Definition
5v
5v Standby
USB W ake-Up
Jum per Settings (JP37)
SCSI Termination (P4SBR
only)
The SCSI termination jumpers allow
you to enable or disable termination
for the onboard SCSI connectors.
The normal (default) position is
open to enable SCSI termination.
See the table on the right for jumper
settings.
Jumper
Position
Open
Closed
Definition
Enabled
Disabled
SCSI T ermination
Jumper Settings
(JPA1, JPA2)
LAN1/LAN2
Use jumper JP35/JP31 to enable or
disable LAN 1/LAN 2, respectively.
See the table on the right for jumper
settings.
SCSI Enable/Disable
(P4SBR only)
Use jumper JP34 to enable or dis-
able the onboard SCSI on your
motherboard. See the table on the
right for jumper settings.
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
SCSI Enable/Disable
Jumper Settings (JP34)
Jumper
Position
Open
Closed
Definition
Disabled
Enabled
LAN1/2 Enable/Disable
Jumper Settings
(J35, J31)