Supero SuperServer 4048B-TRFT, User Manual

Page: 72 / 148

5-24
SUPERSERVER 4048B-TRFT USER'S MANUAL
CMOS Clear
JBT1 is used to clear CMOS, which will also clear any passwords. Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To Clear CMOS
1. First power down the system and unplug the power cord(s). It is also
recommended that you remove the onboard battery from the serverboard.
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
5-10 Jumper Settings
Explanation of Jumpers
To modify the operation of the serverboard,
jumpers can be used to choose between
optional settings. Jumpers create shorts
between two pins to change the function
of the connector. Pin 1 is identi
fi ed with
a square solder pad on the printed circuit
board. See the diagram at right for an
example of jumping pins 1 and 2. Refer to the
serverboard layout page for jumper locations.
Note:
On two-pin jumpers, "Closed" means
the jumper is on and "Open" means the
jumper is off the pins.
Connector
Pins
Jumper
Setting
3 2 1
3 2 1
JBT1 contact pads
LAN Enable/Disable
JPL1 enables or disables the LAN Port1/
LAN Port2 on the X10QBi-A I/O module.
Refer to the table on the right for jumper
settings. The default setting is Enabled.
LAN Enable/Disable
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled