Supero SuperServer 4048B-TRFT, User Manual

Page: 124 / 148

7-34
SUPERSERVER 4048B-TRFT USER'S MANUAL
Alternate ID (Available when RAID is selected in the item above-"Confi gure
SATA as")
Select Enabled for the port speci fi ed by the user to report an alternate ID to the
system. The options are
Enabled
and Disabled.
SATA Port 0/SATA Port 1/SATA Port 2/SATA Port 3/SATA Port 4/SATA Port 5
This section allows the user to con fi gure the following settings for the SATA port
speci fi ed by the user.
Software Preserve
Port 0/Port 1/Port 2/Port 3/Port 4/Port 5
Select Enabled to enable the port speci fi ed by the user. The options are
Enabled
and Disabled.
Hot Plug (Available when AHCI or RAID is selected in the item above-
"Confi gure SATA as")
Select Enabled to support Hot-plugging for the selected SATA port which will al-
low the user to replace a device without shutting down the system. The options
are Enabled and
Disabled.
Port Multiplier (Available when AHCI or RAID is selected in the item above-
"Confi gure SATA as")
Select Enabled to support port-multiplier for the SATA port speci fi ed by the user.
The options are Enabled and
Disabled.
Spin Up Device (Available when AHCI or RAID is selected in the item
above-"Confi gure SATA as")
Select Enabled to allow the PCH to start a COMRESET initialization (from 0
to 1 on an edge detect) to the device. The options are Enabled and
Disabled
.
SATA Device Type
Use this feature to con fi gure the SATA device type for the device installed on
selected a SATA port for use of IDE mode, RAID mode or AHCI mode. The op-
tions are Solid State Device and
Hard Disk Drive
.