Supero SUPERSERVER 2026T-6RF+, User Manual

Page: 106 / 126

7-16
S
UPER
S
ERVER 2026T-6RFT+/2026T-6F+ User's Manual

Super IO Device Confi guration
Serial Port1 Address/ Serial Port2 Address
This option speci fi es the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial port
physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8
as its I/O port address and IRQ 4 for the interrupt address. The options for Serial
Port1 are Disabled,
3F8/IRQ4
, 3E8/IRQ4, 2E8/IRQ3, and 2F8/IRQ3. The options for
Serial Port2 are Disabled,
2F8/IRQ3
, 3E8/IRQ4, 3F8/IRQ4, and 2E8/IRQ3.
Serial Port 2 Attribute
This feature allows the user to set COM 2 as a normal serial port or a virtual COM
port used for SOL (Serial Over LAN). The options are
SOL
and COM.

Remote Access Confi guration
Remote Access
Select Enabled to enable Remote Access support. The options are Disabled and
Enabled
. If Remote Access is set to Enabled, the following items will display:
Serial Port Number
This feature allows the user decide which serial port to be used for Console Redi-
rection. The options are COM 1
and
COM 2
.
Base Address, IRQ
This item displays the based address and IRQ of the serial port speci fi ed
above.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are
115200 8, n 1
; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; and
9600 8, n, 1.
Flow Control
This feature allows the user to set the fl ow control for Console Redirection. The
options are
None
, Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power-On Self-Test (POST).
Select Always to keep Console Redirection active all the time after POST. (Note:
This setting may not be supported by some operating systems.) Select Boot Loader