Supero A+ 122TG-H6IBQRF, User Manual

Page: 91 / 118

Chapter 6: Advanced Chassis Setup
6-15
Installing Add-on Cards (Figure 6-14)
1. Disconnect the chassis from any power source, lay the chassis on a flat
surface, and open the chassis cover.
2. Pull open the add-on card slot clip in the rear of the chassis.
3. Slide the temporary PCI slot shield toward the slot clip and remove the
temporary slot shield from the chassis.
4. Connect the add-on card to the riser card.
5. Secure the riser card to the motherboard tray using the riser card screw.
6. Slide the add-on card bracket into the rear add-on card slot and secure it with
the add-on card bracket screws
7. Close the add-on card slot clip.
Note: Under normal circumstances, the riser card and add-on card bracket are
not separated.
Riser Card
Expansion
Card Screw
PCI Slot
Shield
Expansion
Card
Figure 6-14: Installing the Expansion Card
Important! The Motherboard Node Drawer only accepts add-on cards up to 6.6"
(167.64 mm) in length.