Supero A+ 122TG-H6IBQRF, User Manual

Page: 64 / 118

5-14
A+ SERVER 2122TG-H6IBQRF/H6RF USER'S MANUAL
Overheat LED
Connect an LED to the JOH1 header to
provide warning of chassis overheating. See
the table on the right for pin definitions.
Overheat LED
Pin Definitions
(JOH1)
Pin# Definition
1 3.3V
2 OH Active
UID Button
Pin Definitions
Pin# Definition
1 Ground
2 Ground
3 Button In
4 Ground
Unit Identifier Button
A Unit Identifier (UID) button is located on
the rear of the board. There is another UID
button located on the control panel. When
you push either UID button, both Rear
UID and Front Panel UID Indicators will
illuminate. Push either button again to turn off
both indicators. These UID indicators provide
easy identification of a system unit that may
be in need of service.
Video Connector
A Video (VGA) connector is located below
the COM Port on the IO backplane. This
connector is used to provide video and CRT
display.
Trusted Platform Module Header
This header is used to connect a Trusted
Platform Module (TPM), available separately
from a third-party vendor. A TPM is a
security device that allows encryption and
authentication of hard drives, disallowing
access if the TPM associated with it is not
installed in the system. See the table on the
right for pin definitions.
Trusted Platform Module Header
Pin Definitions
(JTPM1)
Pin# Definition Pin# Definition
1 LCLK GND
3 LFRAME No Pin
5 LRESET VCC5
7 LAD3 LAD2
9 VCC3 LAD1
11 LAD0 GND
13 RSV0 RSV1
15 SB3V SERIRQ
17 GND CLKRUN
19 LPCPD RSV2