Supero A+ 122TG-H6IBQRF, User Manual, Page: 67 / 118

Chapter 5: Advanced Serverboard Setup
5-17
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on the
right for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
I2C to PCI-Express Slot
JI
2
C1/JI
2
C2 allows you to enable the I
2
C bus
to communicate with the PCI-Express slot.
For the jumpers to work properly, please set
both jumpers to the same setting. If enabled,
both jumpers must be enabled. If disabled,
both jumpers must be disabled. See the table
on the right for jumper settings.
I
2
C to PCI-Express Slot
Jumper Settings
(JI2C1/JI2C2)
Jumper Setting Definition
Closed Enabled
Open Disabled
Watch Dog Enable/Disable
JWD enables the Watch Dog function, a
system monitor that takes action when a
software application freezes the system.
Jumping pins 1-2 will have WD reboot the
system if a program freezes. Jumping pins
2-3 will generate a non-maskable interrupt for
the program that has frozen. See the table
on the right for jumper settings. Watch Dog
must also be enabled in BIOS.
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Jumper
JPB is used to enable or disable theBMC
(Baseboard Management Control) Chip and
the onboard IPMI connection.This jumper is
used together with the IPMI settings in the
BIOS. The default position is on pins 1 and
2 to Enable BMC. See the table on the right
for jumper settings.
BMC Jumper Enable (JPB)
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to enable
to enable or disable the LAN1 and LAN2
Ethernets ports. See the table on the right
for jumper settings. The default setting is
enabled.
LAN1/2 En/Disable
Jumper Settings (JPL1)
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled