Supero 2022TG-H6IBQRF, User Manual

Page: 52 / 122

5-2
A+ SERVER
2022TG-H6IBQRF/H6RF USER'S MANUAL
5-2 Connecting Data Cables
This section explains the first step of physically mounting the H8DCT-HLN4F into
the SC827 chassis. The 2022TG-H6IBQRF/H6RF is a highly complicated system.
It is recommended that motherboard removal/installation be done by a Supermicro
trained technician. In case of emergency, following the steps in the order given will
eliminate the most common problems encountered in such an installation. To remove
the motherboard, follow the procedure in reverse order.
Installing to the Chassis
1. Remove the motherboard tray from the SC827 Chassis body.
2. Make sure that the I/O ports on the motherboard align properly with their
respective holes in the I/O shield at the back of the chassis.
3. Carefully mount the motherboard to the motherboard tray by aligning the
board holes with the raised metal standoffs that are visible in the chassis.
Caution: Do not slide the motherboard into a tray as this will damage components on
the bottom of the board.
4. Insert screws into all the mounting holes on your motherboard that line up
with the standoffs and tighten until snug (if you screw them in too tight, you
might strip the threads). Metal screws provide an electrical contact to the
motherboard ground to provide a continuous ground for the system.
5. Install backplane adapter card into JP3 adapter card connector near the front
of motherboard and attach to tray with included screws.
6. Install PCIE x16 Riser Card into PCIE slot & attach to tray with included
screw.
7. Finish by replacing motherboard tray into chassis.
Caution: To avoid damaging the motherboard and its components, do not apply any
force greater than 8 inch-lbs. when installing a screw into a mounting hole.