Supermicro SUPERSERVER 6016T-NTRF4+, User Manual

Page: 111 / 122

Chapter 7: BIOS
7-23
Gateway Address (When IP Address Source is set to 'Static')
The BIOS will automatically enter the Gateway address of this machine; however
it may be overwritten. The value of each three-digit number separated by dots
should not exceed 255.
Mac Address (When IP Address Source is set to 'Static')
The BIOS will automatically enter the Mac address of this machine; however it
may be over-ridden. Mac addresses are 6 two-digit hexadecimal numbers (Base
16, 0 ~ 9, A, B, C, D, E, F) separated by dots. (i.e., 00.30.48.D0.D4.60).
BMC Watch Dog Timer Action
Allows the BMC to reset or power down the system if the operating system hangs
or crashes. The options are Disabled , Reset System, Power Down, Power Cycle.
If the option is set to Reset System, Power Down, or Power Cycle, the following
item will display.
BMC Watch Dog TimeOut [Min:Sec]
This option appears if BMC Watch Dog Timer Action (above) is enabled. This
is a timed delay in minutes or seconds, before a system power down or reset
after an operating system failure is detected. The options are [5 Min] , [1 Min],
[30 Sec], and [10 Sec].

DMI Event Log Confi guration
View Event Log
Use this option to view the System Event Log.
Mark All Events as Read
This option marks all events as read. The options are OK and Cancel.
Clear Event Log
This option clears the Event Log memory of all messages. The options are OK
and Cancel.
PCIE Event Log
Select Yes to activate and display the PCI-Express slot event log. The options are
Yes and No .
Memory ECC Error Log
Select Yes to activate and display ECC Memory Error event log. The options are
Yes and No.