Supermicro SUPERSERVER 1028R-WC1R, User Manual

Page: 74 / 128

5-24
SUPERSERVER
1028R-WC1R(T) USER'S MANUAL
Watch Dog Enable/Disable
Jumper Settings (JWD1)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable
Jumper JPG1 allows the user to
enable the onboard VGA connector.
The default setting is on pins 1-2 to
enable the connection. See the table
on the right for jumper settings.
BMC Enable
Jumper JPB1 is used to enable or
disable the embedded AST2400 BMC
(Baseboard Management Controller)
that provides IPMI 2.0/KVM support on
the serverboard. See the table on the
right for jumper settings.
BMC Enable/Disable
Jumper Settings (JPB1)
Jumper Setting Defi nition
Pins 1-2 BMC Enable
Pins 2-3 Normal (Default)
LAN Enable/Disable
JPL1 enables or disables Gigabit_
LAN ports 1/2 on the X10DRW-i, and
10G_LAN ports 1/2 on the X10DRW-
iT. See the table on the right for
jumper settings. The default setting
is Enabled.
LAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that will reboot the system when
a software application hangs. Close
pins 1-2 to reset the system if an ap-
plication hangs. Close pins 2-3 to gen-
erate a non-maskable interrupt signal
for the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.