Supermicro A+ SERVER 1012C-MRF, User Manual

Page: 75 / 116

Chapter 4: System Safety
5-23
5-10 IDE and SATA Drive Connections
Use the following information to connect the IDE hard disk drive cables.
•
A red mark on a wire typically designates the location of pin 1.
•
The 80-wire ATA133/100/66 IDE hard disk drive cable that came with your
system has two connectors to support two drives. This special cable should
be used to take advantage of the speed this new technology offers. The blue
connector connects to the onboard IDE connector interface and the other
connector(s) to your hard drive(s). Consult the documentation that came with
your disk drive for details on actual jumper locations and settings for the hard
disk drive.
SATA Ports
There are no jumpers to configure
the SATA ports, which are designated
SATA0 through SATA5. See the table
on the right for pin definitions.
SATA Ports Pin Definitions
(SATA0-SATA5)
Pin # Definition Pin # Definition
1 Ground 5 RXN
2 TXP 6 RXP
3 TXN 7 Ground
4 Ground
Power LED
DP2 is an Onboard Power LED.
When this LED is lit, it means power
is present on the serverboard. Be
sure to turn off the system and unplug
the power cord(s) before removing or
installing components.
Power LED
(DP2)
State System Status
On Standby power present
on motherboard
Off No power connected