SuperiorFireplaces.us.com
126872-01C
24
Figure 33 - Control Knob and Igniter Button
Location (Shown as Supplied - No Control
Options)
O
F
F
P
ILOT
LO
IH
AUTO
OFF
ON
O
N
Control Knob
Igniter Button
Flame Adjustment Knob
Selector Switch in OFF
Position
4. Press in and turn control knob clockwise
to the OFF position (see Figure 33).
5. Wait fi ve (5) minutes to clear out any gas.
Then smell for gas, including near the fl oor. If
you smell gas, STOP! Follow “B” in the safety
information, column 1. If you don’t smell gas,
go to the next step.
6. Press in and turn control knob counterclock-
wise
to the PILOT position. Press in
control knob for fi ve (5) seconds
(see
Figure
33
).
NOTE
: You may be running this fi replace for the
fi rst time after hooking up to gas supply. If so,
the control knob may need to be pressed in for
30 seconds or less. This will allow air to bleed
from the gas system.
7. With control knob pressed in, press and release
igniter button. This will light pilot. The pilot is
attached to the front burner. If needed, keep
pressing igniter button until pilot lights.
OPERATION
Continued
NOTE
: If pilot does not stay lit, contact a quali-
fi ed service person or gas supplier for repairs.
Until repairs are made, light pilot with match.
To light pilot with match, see Manual Lighting
Procedure,
Page 25
.
8. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
• If control knob does not pop out when re-
leased, contact a qualifi ed service person or
gas supplier for repairs.
NOTE
: If pilot goes out, repeat steps 4 through
8,
Page 24
.
9. Slightly push in and turn control knob counter-
clockwise
to the ON position.
10. Wait one minute and switch selector switch to
the ON position to light burner.
11. Set fl ame adjustment knob to any level between
HI and LO.
Figure 34 - Propane/LP Gas Pilot
Figure 35 - Natural Gas Pilot
Igniter Electrode
Pilot Burner
Igniter
Electrode
Pilot
Burner
12. To shut off burners only and keep pilot lit, you
can turn control knob clockwise
to
PILOT position, use remote control manual OFF
button, or set selector switch in OFF position.
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise
to the OFF
position.
2a. Set selector switch in the OFF position.
2b. If Using Optional Hand-Held Remote: Set
selector switch in the OFF position to prevent
draining battery.
WARNING: Make sure the remote
selector switch is in the OFF position
when you are away from home for long
periods of time. Appliance will come
on automatically with selector switch
in the ON position.
CAUTION: Do not try to adjust
heating levels by using the equipment
shutoff valve.
