SuperiorFireplaces.us.com
126872-01C
14
INSTALLATION
Continued
4. Route fl exible gas line through access hole in
hearth base.
5. Center cabinet mantel on hearth base
(see
Figure 12
).
Make sure mantel is fl ush against
wall and centered left to right on base.
6. Use screws provided with mantel accessory
to attach mantel assembly to base (see mantel
instruction sheet).
7. Attach fl exible gas line to fi replace gas regula-
tor. See
Connecting to Gas Supply,
Page 18
.
8. Route electrical cord(s) through access holes in
either side of fi replace with bushing. Plug electri-
cal cord(s) into electrical outlet.
9. Check all gas connections for leaks. See
Check-
ing Gas Connections,
Page 20
.
10. Carefully insert fi replace into cabinet mantel
(see
Figure 13
).
Be careful not to scratch or damage
hearth base or cabinet mantel.
11. Place metal trim on shoulder screws located on
the side and top of the fi replace (see
Assembling
Perimeter Trim
). Firmly snap trim over shoulder
screws. Align fi replace in mantel assembly so
the trim overlaps mantel evenly on all three
sides.
12. Lower bottom louver door. Use 3" wood screws
provided with mantel accessory to attach fi re-
place to base (see mantel instruction sheet).
Figure 12 - Installing Cabinet Mantel onto
Hearth Base
Cabinet
Mantel
Hearth
Base
O
F
F
P
IL
O
T
O
N
H
I
L
O
Figure 13 - Installing Fireplace into Mantel
Assembly
Cabinet
Mantel
Assembled
Trim
Hearth Base
Assembling Perimeter Trim
1. Remove packaging from three remaining pieces
of trim.
2. Locate two adjusting plates with set screws, and
two shims in the hardware packet.
3. Align shim under adjusting plate as shown in
Figure 14
.
4. Slide one end of adjusting plate/shim in slot on
mitered edge of top trim
(see
Figure 14
).
5. Slide other end of adjusting plate/shim in slot
on mitered edge of side trim
(see
Figure 14
).
6. While fi rmly holding edges of trim together,
tighten both set screws on the adjusting plate
with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set assembly aside for later installation.
Figure 14 - Assembling Perimeter Trim
Side
Trim
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
Slot
