SuperiorFireplaces.us.com
126872-01C
6
Figure 2 - Removing Screen
Screen
Burner Support
With Log Locator
Tabs
Branch
Support
Shoulder
Screw
ASSEMBLY
Figure 3 - Assembling Hood
Hood Tab
Sheet Metal
Screws
Louver
Baffl e
Firebox Top
Hood
Hood Tabs
WARNING: Always have branch
support and screen in place before oper-
ating fi replace. This prevents excessive
temperatures on fi replace surfaces.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only parts
specifi cally approved with this fi re-
place may result in property damage
or personal injury.
ASSEMBLING FIREPLACE
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
• scissors
1. Remove two screws that hold fi replace screen
in place for shipping. These screws are located
near top of screen. Discard screws. Lift fi replace
screen up and pull out to remove. Set screen
aside until installation has been completed.
2. Cut two plastic straps to remove the log from
the fi rebox cavity.
3. An optional blower is available. See
Accessories
,
Page 34
. Install optional blower now. Follow
installation instructions provided with blower
or
(see
Page 15
).
5. Rotate hood as shown in Figure 3. Make sure
hood tabs point toward fi replace.
6. Insert hood tabs between baffl e and louvers
(see
Figure 3, Page 7
).
7. Gently rotate hood to upright position. Make
sure hood tabs are behind louvers and hood
is resting on fi rebox top
(see
Figure 3
).
8. Align screw holes on hood with screw holes
on fi rebox top.
9. Insert screws as shown in
Figure 3.
Tighten
screws fi rmly.
4. Locate four black phillips sheet metal screws
from the hardware packet.
UNPACKING
1. Remove fi replace and hood from carton. Log
is wrapped and inside fi replace. Do not remove
at this time.
2. Remove all protective packaging applied to
fi replace for shipment.
3. Make sure your fi replace includes one hardware
packet.
4. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
purchased the fi replace.
