Super Products MUD DOG, Operator'S Manual

Page: 105 / 126

TROUBLESHOOTING
Super Products LLC Publication: 0004175 5
-
15
5
Cause Remedy
Electrical Troubleshooting
(continued)
Connector pin not fully
seated inside connector.
Re-seat pin into connector.
Wire pulled out of
crimped pin.
Strip wire and crimp on a new
pin.
Special equipment may be
required.
Only a portion of the
signal path has failed.
Check wiring against the
drawing to determine where
the signal is lost. see-
schematic at end of
troubleshooting section.
Intermittent electrical
connection.
Loose wire connection. Connect an incandescent
lamp to the circuit and wiggle
wires.
Using wire jumpers,
temporarily connect power
and ground to get device to
work.
CAUTION:
Incorrect wiring
may damage device.
Function failed. Device failed. Check LEDs on device.
Replace device.
LED light on proximity sensor
should light up when it
senses steel.
Wires connected to
wrong pin location.
Check wiring against the
drawing. see- schematics at
end of troubleshooting
section
Solenoid shows an open
circuit, infinite
resistance. lights will not
illuminate.
Replace solenoid.
Function will not work
using wired or wireless
pendants.
Assure that LED light polarity
is connected correctly.
Use alternate switch to
operate function.
Function Problem Possible Cause Remedy