40
9.7
Device Monitoring
Click "Device Monitoring" to enter the corresponding interface.
Device information such as real-time values, DC data, initial parameter, protection
parameter, general parameter, device instruction and device information can be viewed
on this interface.
9.7.1 RealTime Values
Realtime information such as power generation, device state, and active power can be
viewed on this interface.
Step 1
Click "Device Monitoring" -> "Realtime Values" to view the corresponding information.
Step 2
Click the button “
” to select the device type.
-- -- E
En
nd
d
9.7.2 DC Data
Click "Device Monitoring" -> "DC data" to view the corresponding information.
On this interface, voltage and current information of multiple inputs of MPPTs and
strings can be viewed.
9.7.3 Initial Parameter
Click "Device monitoring" -> "Initial Parameter" to enter the corresponding interface and
set initial parameters.
Select the meter, set "PT Transformation Ratio", "CT Transformation Ratio", “Meter
Reverse Connection Enable” and "Access Type", click "Save".
When the meter cable is connected reversed, but it is not easy to change the
wiring, the correct meter data can be obtained after opening the meter
reversing enable switch.
The meter reversal function supports single-phase meters and three-phase
meters. Note that only the reverse connection of three phases is supported,
and the reverse connection of one or two of the three phases is not supported.
Select the inverter, initial parameters can be set in two manners: single setting and
batch setting.
9.7.3.1 Single setting
Step 1
Select the desired country (region) and grid type.
Step 2
Click "Settings" to set initial parameters for the single device.
-- -- E
En
nd
d
User Manual
