Sun Oracle SPARC T3-2, Service Manual

Page: 64 / 222

52 SPARC T3-2 Server Service Manual • December 2013
2. Take one of the following actions based on the
show faulty
output:
■
No fault is reported – The system cleared the fault and you do not need to
manually clear the fault. Do not perform the subsequent steps.
■
Fault reported – Go to the next step in this procedure.
3. Use the
component_state
property of the component to clear the fault and
remove the component from the ASR blacklist.
Use the FRU name that was reported in the fault in Step 1 . Example:
The fault is cleared and should not show up when you run the
show faulty
command. Additionally, the System Fault (service required) LED is no longer on.
4. Reset the server.
You must reboot the server for the
component_state
property to take effect.
5. At the ILOM prompt, use the
show faulty
command to verify that no faults
are reported. For example:
Related Information
■
“POST Overview” on page 45
■
“ILOM Properties that Affect POST Behavior” on page 46
■
“Configure How POST Runs” on page 48
■
“Run POST With Maximum Testing” on page 49
POST Output Quick Reference
POST error messages use the following syntax where n =the node number, c = the
core number, s = the strand number:
-> set /SYS/MB/CMP0/MR0/B0B0/CH0/D0 component_state=Enabled
-> show faulty
Target | Property | Value
--------------------+------------------------+------------------
->
n
:
c
:
s
> ERROR: TEST =
failing-test
n
:
c
:
s
> H/W under test =
FRU
n
:
c
:
s
> Repair Instructions: Replace items in order listed by H/W
under test above
n
:
c
:
s
> MSG =
test-error-message
n
:
c
:
s
> END_ERROR