Sun Oracle SPARC T3-2, Service Manual

Page: 56 / 222

44 SPARC T3-2 Server Service Manual • December 2013
3. Clear the fault from all persistent fault records.
In some cases, even though the fault is cleared, persistent fault information
remains and results in erroneous fault messages at boot time. To ensure that these
messages are not displayed, run the following Oracle Solaris command:
For the component referenced in the example in Step 2 (the motherboard) enter
the following command:
Note that you should use one of the following
fmadm
commands released with the
Oracle Solaris 10 05/09 OS based on whether you are replacing a component or
whether you have repaired the component in some way:
■
Use
fmadm repaired
when a physical repair is performed to resolve a
problem with a faulted component. For example, use this command if you have
reinstalled a card after straightening a bent pin and reseating the card.
■
Use
fmadm replaced
when you install a new component to replace a faulted
component and the new component is not automatically discovered by the
system.
Note – The system generally detects new components when a new serial number is
introduced into the system, but in cases where fault information remains, the
fmadm
replaced
command will clear any faults that persist in the system after discovery.
Refer to the
fmadm
man page for more information about these commands.
4. Use the
clear_fault_action
property of the FRU to clear the fault.
Related Information
■
“Oracle Solaris Predictive Self-Healing Technology Overview” on page 39
■
“PSH-Detected Fault Example” on page 40
# fmadm replaced /SYS/MB
# fmadm replaced ********-****-****-****-************
-> set /SYS/MB clear_fault_action=True
Are you sure you want to clear /SYS/MB (y/n)? y
set ’clear_fault_action’ to ’true