Sun Microsystems W1100z, User Manual

Page: 60 / 106

4-12 Sun Java Workstation W1100z and W2100z User Guide • January 2005
6. Follow the instructions for the type of hard disk drive that you are installing:
■
If you are installing additional SCSI drive(s), do the following:
a. Connect drives in bays 1 and 2 to SCSI channel A and drives in bays 4 and 5 to
SCSI channel B.
b. Use the target ID 0 for drives in bays 1 and 4. Use target ID 1 for drives in bays
2 and 5.
Refer to the manufacturer’s documentation that comes with the hard disk drive to
determine the exact jumper settings.
■
If you are installing an additional IDE drive, do the following:
a. Change the jumper settings so that the drive that was installed first is the
master and the newly installed drive is the slave.
Refer to the manufacturer’s documentation that comes with the hard disk drive to
determine the exact jumper settings.
b. Connect the IDE data cable to the newly installed drive.
7. Connect the power cable to the newly installed hard disk drive power connector.
4.5.2 Replacing a CD/DVD Drive
This procedure describes how to remove the CD/DVD drive. See
FIGURE 4-6
when
performing this procedure.
Note –
The replacement CD/DVD drive must be configured the same as the drive
being replaced.
To remove a CD/DVD drive:
1. Turn off the system and all of the peripherals connected to it, then unplug the AC
power cord from the system.
2. Remove the left-side access panel.