Sun Microsystems StorEdge T3+, Installation And Configuration Manual

Page: 94 / 228

72 Sun StorEdge T3+ Array Installation and Configuration Manual • April 2002
▼
To Establish a Network Connection
Use the Ethernet network connection to initialize the network addresses and to
administer the array. The IP address was automatically downloaded by the
JumpStart program when you powered on the array.
Note –
Have the gateway IP address information before beginning this procedure.
Contact the person who maintains your network for this information.
Note –
The telnet session will not connect until the controller LEDs are green.
1. On the host, use the
telnet
command with the array name (or IP address) to
connect to the array.
For example:
Note –
The telnet session verifies whether your network connection is good. If you
cannot connect through the telnet session, see the troubleshooting information in the
Sun StorEdge T3+ Array Administrator’s Manual or the Sun StorEdge Component
Manager User’s Guide to analyze the problem.
2. Type
root
as the login and press Return at the password prompt.
The array displays the banner information, which appears similar to the following:
# telnet
array-name
Trying 129.150.47.101...
Connected to 129.150.47.101.
Escape character is ’^]’.
pSOSystem (129.150.47.101)
Login: root
Password: <
Return
>
T3B Release 2.00 2001/04/02 15:21:29 (192.168.209.243)
Copyright (C) 1997-2001 Sun Microsystems, Inc.
All Rights Reserved.
:/:<1>