Sun Microsystems StorEdge T3+, Installation And Configuration Manual

Page: 87 / 228

Chapter 6 Array Installation 65
Caution – Do not stack more than two arrays together. Stacking more than two
arrays could damage them.
You are now ready to connect the cables.
▼
To Connect the Cables
This section explains how to connect cables for both a workgroup (standalone) and
for an enterprise (partner group) configuration.
Note –
If you are connecting a single array, skip the steps that start with “Partner
group only” and proceed to the next step.
Before you begin, make sure you have all of the required cables and adapters:
■
Fiber-optic cable, one per unit
■
AC power cords, two per unit
■
Interconnect cables, one pair of cables per partner group
■
Ethernet interface cable, 1 per controller unit:
■
10BASE-T (category 3) interface cable for the array (must be purchased
separately)
■
10/100BASE-T (category 5) interface cable for the Sun StorEdge T3+ array
(included with array packaging)
Sun StorEdge T3+ array cables are shown in
FIGURE 6-1
Note –
Your array packaging might not have included interconnect cables. If you
want to install an enterprise configuration and do not have interconnect cables,
contact your Sun sales representative.