Sun Microsystems StorEdge T3+, Installation And Configuration Manual

Page: 107 / 228

Chapter 6 Array Installation 85
5. Verify that the new volume is available to the host system by using the
format(
1M) command on the data host.
Proceed to “Connecting the Host System” on page 89 to continue the installation.
▼
To Configure the Enterprise
To define and mount the default volumes of an enterprise configuration, you must
first make sure the volume on the master unit is mounted, and then add a volume
on the alternate master as follows:
1. On the array, type
vol stat
to check the status of the volume.
Only the volume on the master controller unit is displayed.
Where:
■
v0
is the name of the volume.
■
unmounted
is the status of the volume.
■
u1d1–u1d9
are the disk drives in the volume.
■
0
is the status of the disk drives in the volume.
All the disk drives should show a status of
0
. Possible status messages are listed in
TABLE 6-1
.
■
If the
vol stat
output shows the volume as mounted, skip to Step 4.
■
If the
vol stat
output shows the volume as unmounted, proceed to Step 2.
2. Use the
vol mount
command to mount the volume.
7# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <SUN4.2G cyl 3880 alt 2 hd 16 sec 135>
/pci@1f,4000/scsi@3/sd@0,0
1. c2t1d0 <SUN-T300-0113 cyl 34145 alt 2 hd 64 sec 128>
/pci@6,2000/SUNW,ifp@1/ssd@w50020f23000002ba,0
:/:<1>vol stat
v0 u1d1 u1d2 u1d3 u1d4 u1d5 u1d6 u1d7 u1d8 u1d9
unmounted 0 0 0 0 0 0 0 0 0
:/:<2>vol mount v0