Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library Installation Guide
Document 6423015-01, Ver. 1, Rel. 0
June 2002
16
Installing a Rack Mount Library
7
Insert a no. 2 POZIDRIV screwdriver into the hole and turn the
rack mount clamp screw clockwise to tighten it.
As you tighten this screw, a lever protrudes from the side of the
library and presses against the back side of the rack rail.
8
Repeat steps
to secure the right side of the library to the
rack.
9
Close the magazine access doors.
Proceed to
Installing Drives in the Library
on page 18 to continue
the installation procedure.
Installing an L100 Library
0
To install an L100 library in a rack:
1
Take precautions to ensure that the rack is stable:
• If you are installing the library at the top of a rack with no
equipment at the bottom of the rack, purchase a rack
stabilization kit from the rack manufacturer and install it before
installing the library.
• If you are installing the library in a rack with other equipment,
place the heaviest equipment at the bottom of the rack.
2
Verify that the rack mount shelves are level and securely fastened
to the rack.
3
With the help of another person, lift the library onto the rack
mount shelves.
4
Slide the library all the way into the rack.
5
Press the two white buttons next to the left magazine access doors
and open the doors.
6
Notice the two holes behind the left magazine access doors (see
These holes provide access to the rack mount clamp screws.
Caution:
Do not over-tighten the rack mount clamp screw.
When the screw begins to feel tight, turn it an
additional quarter turn and then stop.
Warning:
The L100 library weighs approximately 162 lbs (74 kg).
At least two people are required to lift and install the
library.