Sun Microsystems Solaris 7 11/99, Hardware Platform Manual

Page: 200 / 224

188 Solaris 7 11/99 Sun Hardware Platform Guide • November 1999
3. Set up the host domain as an install client.
The
add_install_client
command should share the CD across the net. If an
error occurs, you may receive the following warning:
If you receive this warning, use the following
share
(1M) command to correct the
error.
If the
/etc/nsswitch.conf
file contains DNS entry in its host list, you may
receive the following warning:
If you receive this message, you will need to remove the DNS entry in the
/etc/nsswitch.conf
file, add the domain_name to the ethers map, if the name is
not already in the map, and re-run the
add_install_client
(1M) command.
4. Check to see if Patch 105684 has been installed.
If you did not upgrade the SSP software to SSP 3.1.1 or SSP 3.2 and if Patch 105684
is not installed, install Patch 105684-04, at a minimum. You can obtain this patch
from
http://www.sunsolve.com
. Refer to the patch README file for directions
on how to install the patch.
5. Exit the superuser level.
You are done setting up the SSP as a boot server. You can now bring up the domain,
as described in the following section.
ssp# ./add_install_client
domain_name
sun4u
prom_panic: Could not mount filesystem
ssp# share -F nfs -o ro,anon=0 /cdrom/cdrom0/s0
Error:
domain_name
does not exist in the NIS ethers map.
ssp# showrev -p | grep 105684