26
Sun Fire T2000 Server Service Manual • October 2005
Note –
See
TABLE 2-10
for the ALOM ASR commands.
▼
To Run the
showfaults
Command
The
showfaults
command displays faults handled by ALOM. Use the
showfaults
command for the following reasons:
■
To see if any faults have been passed to, or detected by ALOM.
■
To obtain the fault message ID (SUNW-MSG-ID).
■
To verify that the replacement of a FRU has cleared the fault and not generated
any additional faults.
1. At the
sc
> prompt, type the
showfaults
command.
In the following example, a fault is displayed for the front I/O board (FIOBD) and
the motherboard (MB).
2. Use the Sun message ID to obtain more information about the fault.
In a browser, go to the Predictive Self-Healing Knowledge Article web site:
http://www.sun.com/msg
and enter the Sun message ID in the lookup field.
showkeyswitch
Displays the status of the virtual keyswitch.
showlocator
Displays the current state of the Locator LED as either on or off.
showlogs
[
-b
lines
|
-e
lines
] [
-
g
lines
] [
-v
]
Displays the history of all events logged in the ALOM event buffer.
showplatform
[
-v
]
Displays information about the host system’s hardware configuration, and
whether the hardware is providing service.
sc>
showfaults
ID FRU
Fault
0 FIOBD
Host detected fault, MSGID: SUNW-TEST07
1 MB
Host detected fault, MSGID: SUNW-TEST07
TABLE 2-7
Service-Related ALOM Commands
(Continued)
ALOM Command
Description
Summary of Contents for Netra T2000
