Chapter 3
Replacing Hot-Swappable and Hot-Pluggable FRUs
59
FIGURE 3-2
Locating Power Supplies and Release Latch
2. At the
sc>
prompt, issue the
removefru
command.
The
removefru
command prepares the server for the hot swap operation.
For instructions on how to access the
sc>
prompt, refer to the
Sun Fire T2000 Server
Advanced Lights Out Manager (ALOM) Guide
.
Example:
Where
PS
n
is the power supply identifier for the power supply you plan to remove,
either
PS0
or
PS1
.
3. Gain access to the rear of the server where the faulty power supply is located.
sc>
removefru -y PS
n
Are you sure you want to remove PS0 [y/n]?
y
<PS0> is safe to remove.
PS1
PS0
Latches
Summary of Contents for Netra T2000
