Sun Microsystems Netra T2000, Service Manual

Page: 130 / 138

116 Sun Fire T2000 Server Service Manual • October 2005
▼ To Add a PCI-E or PCI-X Card
Follow these guidelines and
FIGURE 5-4
to plan your configuration:
■
The Sun Fire T2000 server provides the following PCI capabilities:
■
3 PCI-E (PCI-Express) slots for low-profile cards (supports lane widths of x1,
x2, x4, and x8)
■
2 PCI-X slots for low-profile cards
Note – There are a variety of PCI-X and PCI-E cards on the market. Read the
product documentation for your device for additional installation requirements and
instructions that are not covered here.
FIGURE 5-4
Location of PCI-E and PCI-X Card Slots
1. Perform all of the procedures in “Common Procedures for Parts Replacement” on
page 67 .
2. Rotate the PCI hold-down bracket (located on the edge of the chassis) 90 degrees
so that the chassis edge can accept the card.
You might need to loosen the screw that holds the bracket to the chassis.
3. Line up the PCI card with the PCI connector on the rear of the motherboard.
4. Push the card into the connector so it is fully seated.
PCI-E slots 0, 1, 2
PCI-X slots 0, 1