Sun Microsystems Fire X4540, Administration Manual

Page: 75 / 154

Chapter 7 Using Disk Control and Monitor Utility (DCMU) 61
Use the
cfgdisk
command to display the status after disconnecting a disk drive:
hotplugmon
The hotplugmon utility monitors disk drive hotplug events and then reports them to
service processor.
hotplugmon
is not a command line utility. To verify a hotplug
event, you should check the corresponding entry in service processor log using
following
ipmitool
commands on the server:
Or from another server type:
faultmond
Command
faultmond
is a daemon that is started at boot time. It scans for faulted disk,
pending disk failures, and FRU information.
Use the
faultmond
command to determine faulted disk drives by using the
parameters shown in
TABLE 7-7
. The following options are supported for the
functions shown:
TABLE 7-4
# cfgdisk
TABLE 7-5
# ipmitool -I open sdr elist
TABLE 7-6
# ipmitool -I lan -H SP-IP -U root -P changeme sdr elist
TABLE 7-7
faultmond
Command Options
Option Description
-h
Displays help information
-t
Displays polling information < minutes >
-v
Displays version information
-D
Runs as a non-daemon process