Sun Microsystems Fire V210, Administration Manual

Page: 63 / 114

Chapter 3 Sun Advanced Lights Out Manager 3-7
3.4.3 To Set the Serial Port Speed Back to the Default
●
Type the following:
3.4.4
scadm resetrsc
Command
If two users are running ALOM at the same time and one user issues the
scadm
resetrsc
command for Solaris OS while the other user is updating ALOM
firmware using either the
scadm download
command or the ALOM shell
command
flashupdate
, the firmware could become corrupted and cause ALOM to
be unusable.
■
Do not issue the
scadm resetrsc
command until after the firmware update is
complete.
■
Do not issue the
scadm resetrsc
command within 60 seconds after the
firmware update has been completed.
3.4.5
TTYB
Console Output
If you have your console set to
TTYB
(10101) rather than to
TTYA
(the ALOM serial
port, labeled SERIAL MGT), you may not see all the output from the console. This is
because both OpenBoot PROM and Power-On Self-Test (POST) send diagnostic
output to
TTYA
by default.
sc> bootmode reset-nvram
sc> reset