Sun Microsystems DGA 5000, Operator'S Manual, Page: 83 / 84

H
HC Residue Check
Pop-up Window 66
See Also Start-up
L
Lambda/AFR Selection, see Gas Analyser
System Settings
Leak Check (Gas), see Maintenance
Leak Check (Vacuum), see Maintenance
Limit Sets 4 6
Editing in Free Measurement 46
LPG Composition, see Gas Analyser System
Settings
M
Maintenance 10 , 52
–
71
Check/Install O2 Sensor 59
Filters 6 3
Gas Analyser Maintenance Menu 20
Gas Calibration Check 5 8
Leak Check (Gas) 55
Leak Check (Vacuum) 52
Periodic Checks 63
Sample Hose & Probe 64
Test Leads 65
Measurement Procedure 35
Measurements
Accuracy 5
Parameters 5
Range/Resolution 5
N
Negative Indications 30
O
O2 Sensor 5 9
O2 sensor Check/Install, see
Maintenance
P
Pop-up Window 6 6
Power 27
Print 24
Sample Printout 25
Vehicle Identification 24
Print Preview 50
Propane Equivalence Factor (P.E.F.) 5
S
Safety Precautions 1
Sample Hose & Probe, see Maintenance
Screen Elements 1 1
Service Dates, see Gas Analyser System
Information
Setup
Fuel Type Selection 32
Lambda/AFR Selection 32
Shut Down Procedure 36
Speed Factor Selection 32
See also Free Measurement
Vehicle Setup
Standby Mode 18
Start-up
Daily Leak Check Requirement 30
DGA 5000 2 7
Gas Analyser 2 7
HC Residue Check 31
Warm up 28
Zero-Calibration 2 9
Startup 28
Summertime Setting, see Gas Analyser
System Settings
SUN System Error Codes 66
System Status Messages 66
T
Test Leads, see Maintenance
Testing Tips 34
W
Warm-up 6 7
See Also Start-up 28
Warning Messages 6 6
Z
Zero Calibration
Pop-up Window 6 7
Zero-calibration, see Start-up 28
I
NDEX