SEAT SWIVEL
LOCK NUT
3 3/4” BOLT,
HAND TIGHT
22
PLATFORM
SECTION
(PN 82073.400)
BASE PLATE (continued)
3.
Position the two Upper Legs as shown in
figure 17
. Slide these
legs into the Base Plate and secure with one
1 3/4” bolt and lock nut
per Leg
(see figure 18)
. Leave these bolts hand tight for now.
UPPER LEG
(PN 82073.300)
UPPER LEG
(PN 82073.300)
ANGLED END
FACING OUT /
BOLT HOLE TO
THE INSIDE
17
18
1 3/4” BOLTS, LOCK NUTS,
HAND TIGHT
1.
Carefully stand the tripod assembly up. The Seat Swivel
bolts to the Leg Base Plate from the top. Pivot the swivel so
that you have access to the bolt holes.
2.
Line up the pivot with the 4 pre-punched holes in the
Leg Base Plate.
3.
The correct order for attaching the swivel is:
1” Bolt,
washer,
Swivel Plate,
1/4” Nylon Spacer,
Leg Base Plate
, Lock
Nut.
See figure 19 and 20.
Leave all bolts hand tight until
they are started and then wrench tighten. All hardware for
the Seat Swivel will be
1/4”-20
thread.
1” BOLT
(PN SU10624)
SEAT SWIVEL
(PN 82073.700)
1/4” NYLON
SPACER
(PN SU10642)
LEG BASE
PLATE
LOCK NUT
(PN SU10612)
STEEL WASHER
(PN SU10625)
19
20
1.
Position one of the Platform Sections as shown in
figure 21
. The
expanded metal side will face up. Line up the section with the bolt
holes near the middle of the Leg Sections and insert one
3 3/4” bolt
in each hole.
2.
Attach another Platform Section next. Slip it over the exposed
bolt from
Step 1
and use one
lock nut
to secure. Leave this hand
tight for now. Use one more
3 3/4” bolt
on the opposite side. See
figure 22
.
PG 8
PLATFORM
SECTION
(PN 82073.400)
3 3/4” BOLTS,
HAND TIGHT
21
Hardware Needed
1/4”-20 - 1” Bolt
- 4
1/4”-20 - Lock Nut
- 4
Steel Washers
- 4
1/4” Nylon Spacer
- 4
Hardware Needed
5/16”-18 - 3 3/4” Bolt
- 9
5/16”-18 - Lock Nut
- 9
PLATFORM ASSEMBLY