PG 11
1.
Carefully lay the completed top section on its side - ladder rungs
up as shown in
figure 36.
2.
Position one of the Coupler Plates as shown in
figure 37.
Slide
the plate over the leg, between the Upper Ladder Assembly and line
up the holes.
NOTE:
Coupler Plate must line up with the round
holes and not the oval holes.
3.
Position one of the Brackets as shown in
figure 38
. The bracket
should be bolted to the Coupler Plate so that it runs horizontally
when the tripod is sitting upright.
4.
Use one
3 3/4” bolt and lock nut
to secure both the Bracket and
Coupler Plate.
36
37
3 3/4” BOLT, LOCK NUT,
WRENCH TIGHTEN
BRACKET
(PN 82073.1300)
5.
Position the 72” Ladder Assembly as shown in
figure 39.
6.
Slide the Assembly into the Coupler Plate and secure with one,
2
3/4” bolt and lock nut.
(see figure 40)
2 3/4” BOLT, LOCK NUT,
WRENCH TIGHTEN
40
7.
Carefully rotate the tripod assembly to gain access to one of the
legs.
8.
Slide another Coupler Plate on the Leg and line up the round
holes as shown in
figure 41.
9.
Position one Bracket as shown in
figure 41
and secure using one
2
3/4” bolt and lock nut.
41
COUPLER
PLATE
(PN 82073.1000)
BRACKET
(PN 82073.1300)
2 3/4” BOLT, LOCK NUT,
WRENCH TIGHTEN
39
72” LADDER
ASSEMBLY
(PN 82073.1100)
38
COUPLER
PLATE
(PN 82073.1000)
Hardware Needed
5/16”-18 - 2 3/4” Bolt
- 8
5/16”-18 - 3 3/4” Bolt
- 1
5/16”-18 - Lock Nuts
- 9
1/4”-20 - 1 1/2” Bolt
- 12
1/4”-20 - Lock Nuts
- 12
12’ LEG ASSEMBLY / LEG BRACES
