PG 15
1.
Position a Coupler Plate and a 72” Leg Assembly as
shown in
figure 56.
The oval pre-punched holes
MUST
be
on the far end of the 72” Leg Assembly.
2.
Line up a Bracket with the upper bolt hole on the inside
of the Coupler Plate as shown in
figure 57.
The Bracket
must attach as before - horizontal to the ground when the
Tripod is standing.
3.
Use two
2 3/4” bolts with lock nuts
to secure the Coupler
Plate, Bracket and 72” Leg Assembly.
BRACKET
(PN 82073.1300)
2 3/4” BOLTS, LOCK NUTS -
WRENCH TIGHTEN
57
4.
Repeat
Steps 1 - 3
for the opposite Leg.
See figure 58.
5.
Locate the pre-punched hole a little further than half-
way down the Leg Assembly.
6.
Position one Bracket over this hole from the inside and
secure using one
2 3/4” bolt and lock nut
as shown in
figure
59
.
You must run this bolt from the inside out so that
the head of the bolt is sitting on the Bracket when tight.
As before, the Bracket should run horizontal to the ground
when the tripod is standing up.
7.
Repeat for the other Leg Assembly. Use one
2 3/4” bolt
and lock nut
to secure these Brackets.
You must run this
bolt from the inside out so that the head of the bolt is
sitting on the Bracket when tight.
58
BRACKET
(PN 82073.1300)
72” LEG
ASSEMBLY
(PN 82073.1200)
COUPLER PLATE
(PN 82073.1000)
2 3/4” BOLTS, LOCK NUTS -
WRENCH TIGHTEN
BRACKET
(PN 82073.1300)
BRACKET
(PN 82073.1300)
59
2 3/4” BOLTS, LOCK NUTS -
WRENCH TIGHTEN
COUPLER PLATE
(PN 82073.1000)
72” LEG
ASSEMBLY
(PN 82073.1200)
Oval hole must be
on far end of leg
assembly
56
Hardware Needed
5/16”-18 - 2 3/4” Bolt
- 9
5/16”-18 - Lock Nuts
- 9
1/4”-20 - 1 1/2” Bolt
- 18
1/4”-20 - Lock Nuts
- 18
16’ LOWER LEG ASSEMBLY
