S One
User’s Manual
OPOS
3-7
The
OPOS origin is set to ‘Current Position’
Upon receiving an OPOS job from the computer, the cutter will immediately start searching for
the OPOS XY line by slowly advancing the media. Once it has found the OPOS XY line, it will
follow this line to the right until it finds the first mark and will then start searching for the
actual first mark. Therefore, the user will have to set the origin under the OPOS XY line,
immediately after the media has been loaded.
This setting was created for jobs that are aligned at the left side and differ a lot in size on the
roll. The origin/tool can then be set to the left of the media, under the OPOS XY line to be able
to find the origin mark, even if it is situated far from the right side of the media.
OPOS o
rigin is set to ‘
Media centre
’
Upon receiving an OPOS job from the computer, the cutter first sets the OPOS sensor in the
middle of the media. Then it will start searching for the OPOS XY line by slowly moving forward
the media. Once it has found the XY line, it will follow the XY line to the right until it finds the
first mark and will then start searching for the actual mark.
This setting has been created for jobs on a roll where the width of each job is at least half the
width of the media (this is usually the case; otherwise there are lots of wasted media). This
method is slightly slower than the previous method.
