S One
User’s Manual
Introduction
1-18
1.
Raise the pinch rollers using the pinch roller lever arm, which is located at the right-hand
side of the cutter, next to the touch panel.
FIG 1-7
1-7
PINCH ROLLER LEVER
2.
Loosen the knobs on the two media core holders. The following illustration shows a
loosened core holder and a tightened core holder .
FIG 1-8
1-8
CORE HOLDERS
3.
Insert a loosened core holder into one end of the media roll and tighten the knob. Verify
that the core holder is secure. Then do the same at the other side of the roll.
4.
Place the roll with core holders on both sides on the media supply rollers. Set the core
holders inside the groove of the core holder guide. The core holder guides can be moved
laterally on the roller.
FIG 1-9
1-9
POSITION MEDIA CORE HOLDER CUTTER
1.5.2
Loading media
