Sumitomo TYPE-71c, Manual To Operation

Page: 91 / 94

6-3
Please contact maintenance service center when it is not recovered if you take the
measures below.
Error message list
Error message Countermeasure
The fibers are not placed correctly in the splicer. Make sure that the right and left fibers are placed in
the correct position of the splicer.
>Refer to page 2-12
The splicer failed to adjust the LED brightness. Clean the microscope lens and LED.
>Refer to page 3-2 and 3-3
The splicer is unable to start splicing because
the hood is open. Close the hood.
Very high voltage is generated with the splicing.
The splicer never starts splicing with opening hood
for safety.
The splicer could not detect the left (right) fiber. Make sure that the left (right) fiber is placed in the
correct position of the splicer.
>Refer to page 2-12
The splicer failed to align the left (right) fiber. Make sure that the left (right) fiber is placed in the
correct position of the splicer.
>Refer to page 2-12
There is a possibility that dust or dirt is on the
V-groove and the fiber clamp when the error occurs
repeatedly. Please execute the cleaning.
>Refer to page 3-2 and 3-3
The splicer failed to adjust the arc gap of the left
(right) fiber.
The splicer failed to inspect the right and left
fibers. Make sure that the right and left fibers are placed in
the correct position of the splicer.
>Refer to page 2-12
The cleave angle of the left (right) fiber exceeds
the allowable limit. Cleave the left (right) fiber again.
>Refer to page 2-10
If the error occurs repeatedly, the cleaver blade
might be deteriorated. Change the blade position or
replace the blade. For further information, refer to
the operation manual of the cleaver. A lip is observed on the left (right) fiber end.
A chip is observed on the left (right) fiber end.
The splicer failed to adjust the focus. Make sure that the right and left fibers are placed in
the correct position of the splicer.
>Refer to page 2-12
Also, please confirm whether dust is on the fiber.
There is a possibility that dust or dirt is on the
V-groove and the fiber clamp when the error occurs
repeatedly. Please execute the cleaning.
>Refer to page 3-2 and 3-3
The splicer failed to splice the fibers. Start the splice again.